Operation - Makita 6936FD Bedienungsanleitung

Fig.7
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Fig.8
Installing and removing hook
A) Removal
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Expand an far end of the hook outward and slide it down
while expanding.
Fig.9
Expand the other far end in the same manner.
Fig.10
Keeping the hook in this position, rotate down to the
angle 90°and remove it by pulling in the direction of
arrow as shown in the figure.
Fig.11
Fig.12
Fig.13
B) Installation
Remove the battery cartridge from the tool.
Place the tool in a stable and level surface.
Hold both hooking ends in the upper position and
expand the upper part of the hook.
Fig.14
Insert both ends, one by one, of the hook into the
grooves in the tool housing.
Fig.15
Fig.16
Keeping the hook in this position, rotate it upwards to the
angle 90°and push both ends fully in the direction of
arrow as shown in the figure.
Fig.17
Fig.18

OPERATION

The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
.
N m
.
(Kgf cm)
M14
80
(1020)
M12
60
(612)
40
M10
(408)
M8
20
(204)
0 1.0
Fastening time
004917
.
N m High tensile bolt
.
(Kgf cm)
120
(1224)
100
(1020)
80
(1020)
60
(612)
M8
40
(408)
20
(204)
0 1.0
Fastening time
004918
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
When fastening screw M8 or smaller, carefully
•
adjust pressure on the switch trigger so that the
screw is not damaged.
Hold the tool pointed straight at the screw.
•
If you tighten the screw for a time longer than
•
shown in the figures, the screw or the point of the
driver bit may be overstressed, stripped, damaged,
etc. Before starting your job, always perform a test
operation to determine the proper fastening time
for your screw.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
7
(M14)
(M12)
(M10)
(M8)
2.0 3.0
M12
(M12)
M10
(M10)
(M8)
2.0 3.0