Fcc Regulations - HP LaserJet 9040/9050 Leitfaden Zur Inbetriebnahme

FCC regulations

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase separation between equipment and receiver.
Connect equipment to an outlet on a circuit different from that to which the receiver is
located.
Consult your dealer or an experienced radio/TV technician.
Opmerking Any changes or modifications to the printer not expressly approved by HP could void the user's
authority to operate this equipment.
Use of a shielded interface cable is required to comply with the FCC rules.
Canadian DOC regulations
Complies with Canadian EMC Class B requirements.
Conforme à la classe B des normes canadiennes de compatibilité électromagnétique (CEM).
VCCI Statement (Japan)
VCCI class B product
Vertaling
Deze apparatuur is IT-apparatuur van de Klasse B-categorie, gebaseerd op de regels van de
Voluntary Control Council For Interference by Information Technology Equipment (VCCI).
Hoewel deze apparatuur gericht is op gebruik in woonwijken, kan er radiostoring optreden
wanneer de apparatuur wordt gebruikt in de nabijheid van een radio of tv. Lees de instructies
voor een correct gebruik.
Korean EMI statement
NLWW Garantie- en overheidsinformatie 211