Maintenance Schedule - Ikra SHES 40 Gebrauchsanweisung

EN ENGLISH
MAINTENANCE
DANGER
Remove the battery pack before starting any
adjustment, cleaning and maintenance work
on the device. Wait until all rotating parts have stopped
and the appliance has cooled down.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body! Never
clean the machine and its components with solvents,
flammable or toxic liquids. Us only a damp cloth making.
Use only original accessories and original spare parts.
Using other spare parts can result in accidents/injuries of
the user. The manufacturer will not be liable for any such
damage.
Please contact our service department if you need
accessories or spare parts.
Only a regularly maintained and treated appliance can
Replacing the guide bar and saw chain
WARNING
Wear protective gloves.
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may
result in severe motor damage.
Failure to replace or repair a damaged chain can
cause serious injury.
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.
Inspecting and cleaning the chain
brake
Always keep the chain brake mechanism clean by lightly
brushing the linkage free from dirt.
Always test the chain brake performance after cleaning..
Refer to "Checking and operating the chain brake"
section in this manual for additional information.
DISPOSAL
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according
collecting/recycling point. By doing so, plastic and
metal parts can be separated and recycled. Information
concerning the disposal of materials and devices are
available from your local administration.
Batteries are not to be put into the rubbish. As a
consumer you are legally obliged to return used batteries
44
serve as a satisfactory aid. Insufficient maintenance and
care can lead to unforeseen accidents and injuries.
Repairs and works specified in these Instructions may
only be performed by qualified authorised staff.
Keep your chain saw professionally maintained and safe.
• Sharpening the chain safely is a skilled task. Therefore,
the manufacturer strongly recommends that a worn or
dull chain is replaced with a new one, available at your
service agent. The part number is available in the product
specification table in this manual.
Follow instructions for lubricating and chain tension
checking and adjustment.
After each use, clean the machine with a soft dry cloth.
Remove any chips, dirt and debris in the battery bay..
Check all nuts, bolts, and screws at frequent intervals
for security to ensure the machine is in safe working
condition. Any part that is damaged should be properly
repaired or replaced by a service station.

Maintenance schedule

Daily check
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners
Chain brake function
Guide Bar
Complete saw
Replacement parts (Bar and chain)
Chain
Guide Bar
Chain must be fitted with bar from the same
manufacturer according to above combinations.
and accumulators. At the end of the duration of your
apparatus, the batteries or accumulators have to be
taken from the apparatus, disposing of them separately.
You have the possibility of delivering your old batteries
and accumulators to the local collecting points of your
municipality or to your dealer or to the distribution
centers.
Dispose of the batteries when discharged. We
recommend applying an adhesive tape on the poles
to protect them against short circuit. Never open the
battery.
Before each use
Before each use and
frequently
Before each use, visual
check
Before each use
Before each use
Before each useInspect
and clean
Before each use
After each use
90PX052X
144MLEA041