Troubleshooting - Party Light & Sound PARTY-MEETY10 Bedienungsanleitung

CHARGING THE UNIT
This speaker has a high capacity battery. Please use the supplied lead for charging.
The power adapter has an indicator light that will illuminate red when the speaker is on charge. It takes
around 6-8 hours to fully charge the speakers. Disconnect the power adaptor as soon as the battery is
fully charged.
Note: When the battery of the speaker is low, please charge it within 48 hours.
Trouble shooting
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem
No sound when power
on
No sound from the
microphone
No sound after inserting
USB/SD card
If Speaker makes loud
noises
Specifications
Power ...................................................................................................................... 500W
Woofer .......................................................................... 10"/25cm with LED illumination
Magnet ..................................................................................................................... 15oz
Voice coil ....................................................................................................................... 1"
Tweeter .................................................................................................................... Piezo
Impedance ............................................................................................................. 4 ohm
SPL (1W/1m) ....................................................................................................... 90±2 dB
Freq. response .............................................................................................. 60Hz-18KHz
Input/ output connectors ................................................................................ JACK/AUX
Battery ....................................................................................... 7.4V 1.8A Li-ion Battery
Power supply .................................................................................. 100-240Vac 50-60Hz
Weight ................................................................................................................... 8.5kgs
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your dealer about the way to
proceed.
©Copyright LOTRONIC 2018
Possible cause
1. No input source
2. Volume down
1. Bad mic connection
2. Mic not switched on
3. Mic volume down
1. Incorrect file format
2. Bad connection of USB/SD card
1. Microphone switched on but
may be too close to the speaker
2. Microphone switched on but is not
being used.
3. Microphone volume may be too
loud
4. Mobile phone is being used too
close to the speaker
5. Other wireless equipment may be
placed very close to the speaker.
PARTY-MEETY10
Solution
1. Connect an AUX signal
2. Adjust volume
1. Plug in the mic properly
2. Switch mic on
3. Increase mic volume
1. File format should be MP3
2. Plug in USB/SD card properly
1. Keep the microphone 2
meters away from the speaker
2. Turn off microphone if not in
use.
3. Adjust microphone
volume to lower mode
4. Keep mobile away from the
speaker whilst attending a call.
5. Keep the speaker away from
other wireless equipment
5