Troubleshooting - Party Light & Sound PARTY-SP500 Bedienungsanleitung

Trouble shooting
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem
No sound when power
on
No sound from the
microphone
No sound after inserting
USB/SD card
If Speaker makes loud
noises
Specifications
Woofer
Titanium driver
Max. power
Magnet
Voice coil
Freq. response
Sensitivity
Impedance
Input voltage
VHF mic frequencies
Built-in Lithium battery
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
©Copyright LOTRONIC 2016
Possible cause
1. No input source
2. Volume down
1. Bad mic connection
2. Mic not switched on
3. Mic volume down
1. Incorrect file format
2. Bad connection of USB/SD card
1. Microphone switched on but
may be too close to the speaker
2. Microphone switched on but is
not being used.
3. Microphone volume may be
too loud
4. Mobile phone is being used too
close to the speaker
5. Other wireless equipment
may be placed very close to the
speaker.
PARTY-SP500
12"/30cm
1.5"
500W
15oz
1.5" KSV
45Hz – 15kHz
92dB (+/-2dB)
4 ohm
100-240Vac 50/60Hz
203.6MHz / 208.8MHz
11.1V 1500mAh
PARTY-SP500/SP700
Solution
1. Connect an AUX signal
2. Adjust volume
1. Plug in the mic properly
2. Switch mic on
3. Increase mic volume
1. File format should be MP3
2. Plug in USB/SD card properly
1. Keep the microphone 2
meters away from the speaker
2. Turn off microphone if not in use.
3. Adjust microphone
volume to lower mode
4. Keep mobile away from the
speaker whilst attending a call.
5. Keep the speaker away from
other wireless equipment
PARTY-SP700
15"/38cm
1.5"
700W
20oz.
1.5" KSV
40Hz – 15kHz
93dB (+/-2dB)
4 ohm
10-240Vac 50/60Hz
203.6MHz / 208.8MHz
11.1V 1500mAh
5