Emptying Of Dust Collector; Cleaning And Maintenance; Service Centre - Probuilder 43627 Gebrauchsanweisung

Allow the multi-sander to reach full speed.
Apply the sander to the item. Give it time to
work. It is rarely necessary to press the pad
hard against the surface to be worked.
Lift the multi-sander from the work piece
after use, and turn it off by pressing the
on/off button to the OFF position.
Avoid blocking the ventilation holes with
your hand, as the multi-sander can otherwise
become overheated.

Emptying of dust collector

The dust collector should be emptied before
it becomes completely full.
Turn the dust collector slightly anti-clockwise
and push it off er the dust extraction spigot.
Dispose of the sanding dust carefully and in
accordance with the regulations that apply in
your municipality.
Place the dust collector onto the multi-
sander before you resume work.

Cleaning and maintenance

Clean the multi-sander with a damp cloth
after use and always keep its upper surface
and ventilation openings free of dirt.
Never use corrosive or abrasive detergents,
as they may aff ect the plastic parts on the
multi-sander.
22
Replacing the sanding pad
If the sanding pad or hook-and-loop surface
on the sanding pad is damaged, it must be
replaced. Unscrew the screws under the
hook-and-loop surface and detach it. Attach
a new hook-and-loop surface and screw the
screws into the multi-sander's screw holes

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• www.schou.com
A
5
6