Measurement With The Desired Systolic Pressure; Notes For Proper Measurement - A&D UA-767 Plus 30 Bedienungsanleitung

Measurement With The Desired Systolic Pressure

If your systolic pressure is expected to exceed 230 mmHg or you use the
optional small cuff, use this procedure.
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the START button.
Release the button when the average
of all the data in memory is displayed.
Press and hold the
again until a number about 30 to 40
mmHg higher than your expected
systolic pressure appears.
3. Release the START button to start
measurement,
number is reached. Then continue to
measure your blood pressure as
described on the previous page.

Notes For Proper Measurement

Sit down in a comfortable position. Place the
arm to be used for the measurement on a
table or other support so that the center of the
cuff will be at the same height as your heart.
Relax for about five or ten minutes before taking a measurement. If you
are excited or depressed by emotional stress, the measurement will
reflect this stress as a higher (or lower) than normal blood pressure
reading and the pulse reading will usually be faster than normal.
An individual's blood pressure varies constantly, depending on what you
are doing and what you have eaten. What you drink can have a very
strong and rapid effect on your blood pressure.
This device bases its measurements on the heartbeat. If you have a very
weak or irregular heartbeat, the device may have difficulty determining
your blood pressure.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. Refer to page 4 for the
description of symbols.
This blood pressure monitor is intended for use by adults only. Consult
with your physician before using this device on a child. A child should not
use this device unattended.
Measurements
START button
when the desired
English 9
At heart level
Press and hold the button
Release the button
when the average
is displayed.
Press and hold the button
Starts inflation
Release the button
at the desired
systolic pressure
Refer to the previous page
for measurement