Measurements; Normal Measurement - A&D UA-767 Plus 30 Bedienungsanleitung

Model UA-767
cuff to a systolic pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg or you use the
optional small cuff, read "Measurement With The Desired Systolic
Pressure" on the next page.

Normal Measurement

1. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2. Press the
START
The average blood pressures and last data
number are displayed briefly. Then the
display changes, as indicated in the figure
at the right, as the measurement begins.
The cuff starts to inflate. It is normal for the
cuff to feel very tight. A pressure bar
indicator is displayed, as in the figure at
the right, during inflation.
Note: If you wish to stop inflation at any time,
press the
3. When inflation is complete, deflation starts
automatically and the
blinks, indicating that the measurement is
in progress. Once the pulse is detected,
the mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
4. When the measurement is complete, the
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
5. Press the
off the power.
Note: The device has an automatic power shut-off function, which turns the
power off approximately one minute after measurement. Allow at
least ten minutes between measurements on the same person

Measurements

30 is designed to detect the pulse and to inflate the
button.
button again.
START
button again to turn
START
(heart mark)
English 8
At heart level
button
START
Averaged data
Data number
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
air automatically