Troubleshooting; Specifications - Somogyi Elektronic SFP 40 Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Caution: Risk of electric shock!

Do not attempt to disassemble of modify the unit or its accessories. In case any part is damaged,

immediately power off the unit and seek the assistance of a specialist.

In the event that the power cable should become damaged, it should only be replaced by the

manufacturer, its service facility or similarly qualified personnel.

FEATURES

40 cm diameter • adjustable fan speed (3 levels) • stationary or oscillating (90°) • wind function (2 levels) • timer (30 minutes – 7.5 hours) • all functions can be remote-

controlled • adjustable height (110 - 130 cm)

ASSEMBLY

1. Remove the packaging carefully; avoid scratching the plastic cover with the scissors or knife.

2. Attach the rear part of the grid to the engine.

3. Put on the grid holder screw.

4. Attach the fan to the axis, then fasten it with the fan holder screw.

5. Then attach the front part of the grill to the fan and fasten it using the tabs.

6. Assemble the stand as described below, and attach the just finished fan assembly.

ASSEMBLY OF THE STAND

1. Attach the bottom stand section (12) to the base using a screw.

2. Set the desired height and fasten it with the fastening ring (11).

3. Then mount the fan assembly on it. Fasten using the screws.

OPERATING THE FAN

Set the fan on a stable and horizontal surface. Plug the power supply cable into a wall outlet. The POW LED will illuminate to confirm that the fan has been powered on.

Once the fan is assembled, you can control it with the buttons on the control panel. All functions can also be remote-controlled.

To start the fan, press ON/SPEED; pressing this button repeatedly toggles between the 3 speed levels. To stop the fan, press the OFF button. The fan can also oscillate;

to switch this movement on and off, press SWING. The active or disabled state of each function is indicated on the control panel (red LEDs).

WIND FUNCTION

The fan creates air flow that is reminiscent of natural wind, further enhancing your sense of comfort. There are two types of such air flow: NAT (natural wind) and SLE

(softer natural wind). To use the wind feature:

1. Press MODE repeatedly to toggle between NAT and SLE.

2. To switch off, use the MODE button again to cycle to the NOR (normal mode) function.

TIMER

You can set a timer that will switch the fan off automatically. The switch-off time can be adjusted between 30 minutes and 7.5 hours, in intervals of 30 minutes. To

activate this feature:

1. Set the switch-off time using the TIMER button. A red LED above the active value indicates the selected time; when multiple numbers are lit up, the switch-off time is

the sum of these.

2. To disable the switch-off function, press TIME repeatedly until none of the LEDs above the time values is lit up.

CLEANING & MAINTENANCE

In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.

1. Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning.

2. Warning: Only remove the front protective grille from the fan if it has been powered off.

3. Use a slightly moistened cloth to clean the unit's exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the

appliance.

4. Warning: Only replace the front protective grille on the fan if it has been powered off.

5. Only power on the fan after this has been done.