Troubleshooting - Somogyi Elektronic home TWFR79 Bedienungsanleitung

ASSEMBLY AND INSTALLATION OF THE UNIT
1. Remove the packaging carefully taking care not to damage the plastic body with scissors or knife.
2. To assemble the unit, prepare the base which consists of two halves and the 3 enclosed screws.
3. According to sequence written in Figure 3., put the two parts of the base to the bottom of the fan, and
fix them with the included screws.
4. Lead the power cable on the bottom part of the base through the cable outlet groove, make sure that
it is not pinched and its insulation is not damaged.
5. Before setting the appliance on its base, confirm that the power cable can move freely and is intact.
6. Set the unit on a stable and horizontal base, keeping it away from radiating heat sources and naked
flame.
7. Place a CR2025 type button battery to the remote controller. Pay attention to the correct polarity.
8. Only connect the unit to the mains after this has been done.
Caution: Risk of electric shock! Do not attempt to disassemble or modify the unit or its
accessories. In case any part is damaged, immediately power off the unit and seek the
assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the
manufacturer, its service facility or similarly qualified personnel.
FEATURES
small footprint tower fan • touch panel and remote controller • 3 speed levels • 3 fan operation modes (NORMAL, SLEEP, NATURAL) • switchable oscillation • 7,5-hour
timer
Figure 1.: 1. carrying handle • 2. touch panel • 3. protective grid • 4. base •
5. power cable • 6. remote controller
FAN OPERATION
Following functions can be controlled both with the touch panel and the remote controller as well. Selected functions are indicated with LEDs.
With (7) button, you can turn on or off the fan. After switching on the fan, it will start operation on the highest speed level.
With SPEED (10) button, you can select between small
With MODE (11) button, operation modes can be selected: natural
built-in program, and the unit will ignore the speed, which has been set with SPEED button.
By pressing OSC (8) button, fan oscillation with approx. 75° angle can be switched on or off.
With TIMER (9) button, you can set switching-off time up to 7,5-hour timing with 0,5 hour increments. The remaining time will be indicated by lighting LEDs with 0,5
hours accuracy.
CLEANING
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
1. Prior to cleaning switch off and power off the unit by unplugging it from the electric outlet!
2. Use a slightly moistened cloth to clean the unit's exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the
appliance!
3. Reinstall the fan!

TROUBLESHOOTING

Malfunction
The fan does not turn on.
The fan does not respond to the remote control signal.
Waste equipment must not be collected separately or disposed of with household waste because it may contain components hazardous to the environment or
health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and
function. Dispose of product at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of
others and yourself. If you have any questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer
as prescribed in the relevant regulations and shall bear any associated costs arising.
TECHNICAL SPECIFICATION
Power supply: . . . . . . . . . . . . . . . . . . . . . . . . . 230 V ~ / 50 Hz / 40 W
Appliance protection class: . . . . . . . . . . . . . . . II.
Remote controller power supply: . . . . . . . . . . 1 x CR2025 (3 V)
Maximum fan - air mass volume: . . . . . . . . . . F = 22,18 m /min
Fan input power: . . . . . . . . . . . . . . . . . . . . . . . P = max 38,40 W
Service value: . . . . . . . . . . . . . . . . . . . . . . . . . SV = 0,58 (m /min)/W
Power consumption during standby mode:. . . P = 0,38 W
, medium , or high fan stages.
, night , or normal. In these operation modes, the fan speed will be adjusted according to the
Possible solution
Check the power supply!
Check the capacity of remote controller's battery.
3
3
SB
Figure 2.: 7. ON/OFF switch • 8. oscillation • 9. timer • 10. speed level • 11.
operation mode
Fan acoustic power level: . . . . . . . . . . . . . . . . L = 55,65 dB(A)
Maximum air speed: . . . . . . . . . . . . . . . . . . . . c = 1,88 m/sec
Service value standard: . . . . . . . . . . . . . . . . . IEC 60879:1986
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (corr. 1992)
Length of power cable: . . . . . . . . . . . . . . . . . . 1,6 m
Dimension: . . . . . . . . . . . . . . . . . . . . . . . . . . . Ø18 x 79 cm
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,6 kg
WA