Gps Navigation Systems; Charging The Battery - Uvex boss 525 bt Bedienungsanleitung

Note: if a previously paired helmet and MP3 player do not connect, switch both
devices off and on again. If the problem persists, repeat the pairing operation.
If the helmet is also paired with a cellphone, the music will be interrupted automatically
when a call is received. It is therefore possible to answer the call by pressing the
"HELMET" button (short press).
Note: after being switched on, the connection between some players and the
helmet must be established by pressing the "HEADSET" button briefl y. We
recommend users always check the method of operation and options offered by
the A2DP device to be used.

2.6 GPS NAVIGATION SYSTEMS

2.6.1 Pairing a GPS navigator with the UVEX BLUETOOTH system
Use the navigator to manage Navigator/helmet pairing.
Consult the section in the handbook for your Bluetooth® enabled navigator dealing
with pairing with Bluetooth® devices. This procedure is different for every navigator.
The various steps required are identical to those described in previous paragraph
("2.4.1 Connecting a Bluetooth® cellphone to the UVEX BLUETOOTH system"), so
repeat points 1 to 8 using the GPS rather than the phone.
When a connection has been established between the helmet and Bluetoothâ
navigator, the helmet can receive GPS instructions.
If pairing is not successful, switch off the helmet (see "how to switch off the helmet")
and repeat the pairing procedure from the beginning.
Note: the functions described may vary according to the type of navigator or
the software updates for each navigator, which may affect compatibility with the
UVEX BLUETOOOTH system.
The procedure for using the helmet in connection with satellite navigator is as
follows:
1 – Switch off the helmet.
34
ENGLISH
2 – Switch on the previously paired satellite navigator.
3 – Switch on the helmet. The helmet and navigator are connected and instructions
from the navigator can be heard in the helmet.
If you want to use a cellphone as well as the navigator, the cellphone should be paired
with the navigator, not the helmet. To do this, consult the navigator handbook.
If no connection can be established between a previously paired helmet and navigator,
switch both the devices off and on again. If the problem persists, repeat the pairing
operation.
Note: after being switched on some navigators must be connected to the helmet.
We recommend users always check the method of operation of your Bluetooth
device and the options offered.

2.7 Charging the battery

The UVEX BLUETOOTH system is powered by a rechargeable battery. Before using
the UVEX BLUETOOTH communications system the battery in the helmet must be
charged.
Only use UVEX approved batteries and battery chargers.
When you decide to use your UVEX BLUETOOTH system for the fi rst time, make
sure the battery is fully charged. After this the battery can be recharged for shorter
periods, although when possible it is better to complete the full recharge cycle. A
partial recharge does not guarantee total autonomy.
New batteries reach peak performance only after being fully charged and discharged
two or three times.
Attention: The helmet should not be worn during recharging process.
Attention: do not use the batteries for anything but their intended purpose. Never
use a damaged battery charger or batteries.
Note: The battery can be discharged and recharged hundreds of times, but will
eventually become exhausted with use. When continuous conversation times
seem much shorter than usual the battery must be replaced.
35
ENGLISH