Use With Cellphone - Uvex boss 525 bt Bedienungsanleitung

5 – Select STILO BT x.x xx device.
6 – When cellphone requests password, enter 0000.
7 – The helmet emits a high tone and the LED on the helmet console switches from a
rapid to a slow fl ash. The pairing is complete.
8 – To store pairing data in the memory, switch both the cellphone and the helmet off
and on again. The information will be stored in the helmet memory and will not be lost
whenever the helmet is turned off again. As a result, every time the helmet is turned
on it will connect automatically with the previously paired cellphone.
Note: If pairing is not successful, turn off the helmet (see "how to turn off the
helmet") and repeat the pairing process from the beginning.
Note: after pairing, some cellphones must be connected to the helmet by
pressing the "HEADSET" button for 2 seconds. With these cellphones, every time
the helmet is switched on the "HEADSET" button must be pressed (2 seconds) to
connect them to the helmet.
Check your cellphone handbook for information.

2.4.2 Use with cellphone

Note: the functions described may vary according to the type of cellphone or the
various software updates for each model.
Note: cellphone software updates may affect compatibility with the UVEX
BLUETOOTH system.
Note: using the system at high volumes can damage hearing, distract drivers,
create dangerous situations and reduce the driver's ability to hear external
sounds. Please regulate the volume to the lowest practical level before using the
system when the motorbike is in operation.
After completing the pairing procedure to use the helmet with cellphone, simply
switch on the Master or Slave helmet.
After a few seconds the helmet is ready to operate with its paired cellphone, which
30
ENGLISH
should, of course, be switched on.
If the helmet and paired cellphone cannot fi nd each other, switch both devices off and
on again. If the problem persists, repeat the pairing operation.
Note: after being switched on some cellphones must be linked to the helmet by
pressing the "HEADSET" button (medium press).
Check operational functions and possible special options in your cellphone
handbook.
A helmet that is already switched on and in operation with the cellphone can be
connected to another helmet that is switched on and previously paired.
Use a medium press on the "HELMET" button on one of the helmets.
The helmets must be less than 10 metres apart.
Answering a cellphone call.
A tone will be heard over the headset loudspeakers when the cellphone paired with the
helmet receives a call (some cellphones transmit their own ringtone to the helmet).
To accept the call, press the "HEADSET" button (short press).
Whenever the two helmets are in intercom mode, if you accept the call (short press on
the "HEADSET" button) you will break the intercom connection.
This temporary interruption of the connection is indicated in the other helmet by a tone
in the headset. At the end of the call the intercom connection between the two helmets
is re-established automatically. It is not necessary to press any of the buttons.
Note: by "the end of the call", we mean that the caller hangs up.
A call can be refused or interrupted at any moment by pressing the "HELMET" button
on the Master helmet for 2 seconds.
Making a cellphone call.
When the helmet is switched on it is possible to make call as normal on the cellphone.
After entering the number and sending the call, communications are automatically
handed over to the helmet.
Note: if a cellphone does not connect automatically to the helmet when switched
on, make sure that the cellphone is connected to the helmet before making a call
(see point 2.4).
31
ENGLISH