Basic Functions - Uvex boss 525 bt Bedienungsanleitung

To enable the helmet to communicate with another helmet, cellphone, MP3 player and
GPS system it must be paired with all these devices. When the intercom function is in
operation, either helmet, Master or Slave, can operate with the cellphone it is paired
with. Whenever the cellphone receives a call this will be signalled by a repeated tone
or a ringtone in the headset. To answer the call, simply press the "HEADSET" button
on the helmet (for further functions available with cellphone see "Use with cellphone"
section). All pairings remain stored in the memory when the headset is turned off
and are also retained when it is switched on again. As a result repeating the pairing
procedure is only necessary when the user wishes to change the helmet, cellphone
or other device to be in communication with. No other instruments are needed for
pairing, and the procedure can be carried out at any time.

2.2 Basic functions

The following basic functions can always be carried out with the helmet:
Note: before switching on the helmets, read the paragraphs "Intercom" and
"Cellphone" below.
Switching on the helmet: press the "HELMET" button for 4 seconds until the LED
shows a steady light, confi rmed by the headset tone. Release the button. The LED
begins to fl ash slowly – the helmet is on.
Switching off the helmet: press the "HELMET" button until the LED shines steadily
and the low off tone sounds in the headset. Then release the button and wait for the
LED to go off.
Note: if the system does not respond to the button commands, recharge for
a short time (5/10 minutes). The system will reset. If the battery is completely
discharged, simply charge for a few minutes to check correct functioning.
Adjusting volume:
To increase the volume press the "HEADSET" button. Every time the "HEADSET"
button is pressed briefl y, confi rmed by a headset tone, the volume will increase until
it reaches the maximum level, indicated by a high tone.
The volume has 7 levels. To lower the volume, press the "HELMET" button. Every
26
ENGLISH
time the "HELMET" button is pressed briefl y the volume decreases until it reaches the
lowest level, indicated by a low tone.
Note: for the intercom function we recommend starting with the volume at its
lowest setting and increasing it gradually until the voice is at the optimum level.
Excessive volume can cause intrusive background noise. The cellphone function,
however, creates no background noise problems so the volume can be regulated
as desired.
Note: very high volumes can damage hearing, distract the driver, create dangerous
situations and make external sounds more diffi cult to hear - regulate the volume
to the lowest useful level before using the system while riding.
27
ENGLISH