Insert Or Replace Batteries; Time And System Setup; Unit Conversion Mmhg/Kpa; Who Blood Pressure Classification Display - Cresta BPM 220 Bedienungsanleitung

INSERT OR REPLACE BATTERIES

• Remove the battery cover.
• Insert new batteries into the battery compartment as shown, taking care
that the polarities (+) and (-) are correct.
• Close the battery cover. Use only LR03, AAA batteries.
Dispose of empty batteries to the authorized collecting
party subject to the regulation of each individual territory.
CAUTION
Insert the batteries as shown in the battery compartment. If not, the device
will not work. When LOW BATTERY mark - blinks in the display, replace all
batteries with new ones. Do not mix old and new batteries. It may shorten
the battery life, or cause the device to malfunction. LOW BATTERY mark
does not appear when the batteries run out. Please ensure to distinguish
positive polar "+" and negative polar "-" of batteries when replacing batteries.
Batteries, which have fluid on the surface or are modified, cannot be inserted
into the product. Battery short circuit must be prevented.
Battery life varies with the ambient temperature and may be shortened at
low temperatures. The batteries may leak and cause a malfunction.
Use the specified batteries only. The batteries provided with the device are
for testing the monitor performance and may have a shorter lifecycle.
Used batteries may leak and damage the main unit. lf you are not going to
use the unit for a long period of time (approximately three months or more),
remove the batteries. Replace worn batteries with their polarities in the
correct direction.
8
TIME AND OF SYSTEM SETUP
1. Press "SET" key to turn on.
2. Press and hold the "SET" key until the year number displays and flashes
in the LCD display to enter setting mode.
3. Press the "MEM" key to adjust the year, then press the "SET" key again
to save your setting and enter the month setting mode.
4. Press the "MEM" key to adjust the month. Following the same steps to
adjust date/hour/minute.
year month
UNIT CONVERSION mmHg/kPa DISPLAY
The default setting of the monitor is mm Hg. Also kPa (kPa) can be set.
Boost continued to press the ON/OFF button exceeding five seconds.
The units will be chosen by the above shows mmHg/kPa after decontrol.
After the normal boot unit values are shown as blood pressure. Also select
memory unit value changes.

WHO BLOOD PRESSURE CLASSIFICATION DISPLAY

Diastolic blood pressure Reference material: journal of hypertension 1999.
vol 17 No.2
Grade 3 hypertension (severe) Grade
2 hypertension (moderate) Grade
1 hypertension (mild)
High-normal
Normal
Optimal
date hour minute
9