Inflating/Deflating - Westfield HYDRA 300 Anleitung

INFLATING/DEFLATING

Safety
Pressure
Valve
Pressure
Gauge
Inflation
The included pump is equipped with an overpressure valve. This
prevents you from overfilling the air tube. The ideal air pressure is
7 PSI (0.48 bar). To inflate your awning:
• Ensure that the valves on the awning are screwed in correctly.
• NOTE: Please take care when screwing the valves in that you do
not kink the valve seals when screwing them together as this can
lead to damaging the valve.
• The valves on the awning should be out
• Connect the overpressure valve to the pump and check that the
pump is set to inflate.
• Open the screw cap of the valve on the awning and connect the
pump to the valve.
• Inflate the awning using the pump until either the correct pressure is
reached or you hear the air coming out of the overpressure valve.
• NOTE: Do not use compressed air compressors, as these may
have a far higher operating pressure and can permanently damage
the TPU air tubes.
Deflation
To deflate the air tube, carefully unscrew the valves out of the air
tubes. Please be aware that the air will rush out very quickly so
unscrew the valve slowly to help release the pressure slowly.
To help with packing the awning away, the valves should be left out
as this allows any trapped air to escape when the awning is packed
away.
3