Bahco BCL32G1 Bedienungsanleitung Seite 8

Charging the Battery Pack
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
3. Push the battery pack into place and make sure the red light on the
4. A fter finish the charging cycle, the light will turn into green.
5. Your new battery pack is not charged. You need to charge it before use.
6. A lways use the specified charger to charge the battery. When the
7. W hen you charge a new battery pack or a battery pack which has not
This is a normal condition and does not indicate a problem. You can recharge the battery pack
fully after discharging it completely a couple of times.
8. U nplug the charger from the power source after finish the charge.
9. Please remove the battery from the unplugged charger for storage.
The LED Light on the Charger
Power On (Green light flashes slowly)
Battery Low (Red light stays illuminated)
Battery charged 80% (Green light flashes rapidly)
Battery charged 100% (Green light stays illuminated)
Battery Pack temperature is too hot or too cold (Red light flashes slowly)
Battery Pack malfunction (Red and Green lights stay illuminated)
Battery Pack LED Indication Function (Optional)
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity
status. The fuel gauge green LED will indicate when the "SW" button is momentarily pressed.
Remaining Capacity LED Indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
WARNING
1. C harger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack
and the red Indicator light is "blinking". When the battery pack temperature returns to
between 0°C (32°F) and 50°C (122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is
defective. Please contact your retailer.
on the charger.
charger is "ON". The battery pack is now starting the charging cycle.
The battery pack is now ready for use.
battery pack is inserted into the charger correctly, the red light will
come on and charging will begin.
been used for a long period, it may not accept a full charge.
• 8
RC Status
0%-25%
26%-50%
51%-75%
76%-100%
•