Bahco BCL32G1 Bedienungsanleitung Seite 10

Disengaging
Key
Slot
Suction Filling (From Bulk Container)
1. U nscrew and dis-assemble tube cap from the container tube as Fig. 4.
Screw
(for Gun Head)
Lip
2. Visually check the direction of plunger lip.
3. C hange the lip direction of plunger by your finger. The lip must be directed toward the gun
head.
4. S crew and re-assemble tube cap from the container tube.
5. Insert the open end of grease container ass'y into lubricant of bulk container. Draw back
piston rod slowly while pushing the grease container ass'y deeper into the lubricant to
prevent air pocket. See Fig. 5.
6. W hen piston rod is fully extended, latch the groove of piston rod into the slot of tube cap.
7. Screw grease container ass'y into gun.
8. Release the piston rod from slot and push it all the way in.
9. This gun is ready to use. If your gun fails to work, to remove the air, procedure as "Remove
Air Pocket".
Plunger Handle
Pistor Rod
Plunge
Container
Plung
• 10 •
Engaging
Pistor Rod
Slot
Plunger Handle
Tube Cap
Pistor Rod
Slot
Key
Fig. 3
Fig. 4