Electrical Connection - Hella RALLYE 4000 Montageanleitung

EN
ENGLISH
Mounting steps: Page 9 – 10
The lights can only be mounted in
an upright position.
The lights must not vibrate or jut
out above the bonnet, and must be
mounted symmetrically. Determine
the mounting position and mark the
fastening points.
Drill using a 3 mm drill bit, and drill
out to 11 mm. Seal drilled metal
20
parts with rust protection.
TOP TOP
max.
4 m
When fitting the lights, ensure that
the light is mounted horizontally.
Align the light in accordance with
the drawing and tighten the screws.
Fit the relay with the connection
terminals pointing downwards in a
Lay and connect the cables in ac-
waterproof manner. If required and
cordance with the circuit diagram.
if legally permitted, fit a switch in
(Page 14, 15, 16, 17)
the dashboard.
According to circuit diagram A, the
driving lights are switched on to-
gether with the existing spotlights.
According to circuit diagram B, the
auxiliary lights are switched on in
Keep the cover lenses clean. Dirt
addition to the existing headlights
may absorb up to 80% of the light
via a separate switch.
emitted.
It is however essential that
country-specific laws are
observed.
Check the lighting system, fasten
the connection cables securely.
Have the driving lights adjusted
at a specialist garage.
Only correctly adjusted lights
provide optimum light.

Electrical connection:

page 14, 15, 16, 17
A useful tip: