Herunterladen Inhalt Inhalt Diese Seite drucken

General Information; Remote Control, Power Supply - Philips mc 145 Benutzerhandbuch

Vorschau ausblenden Andere Handbücher für mc 145:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43

GENERAL INFORMATION

Supplied accessories
– 2 speaker boxes
– Remote control
– 2 batteries for the remote control, size AAA
– AM/MW frame aerial
– FM aerial wire
– Mains lead
General maintenance
Do not expose the unit, batteries
or CDs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).
You can clean the unit with a
soft, slightly dampened lint-free
cloth. Do not use any cleaning
agents as they may have a
corrosive effect.
Environmental information
All redundant packing material has been omitted. We have
done our utmost to make the packaging easily separable into
three mono materials: cardboard (box), polystyrene foam
(buffer) and polyethylene (bags, protective foam sheet).
Your unit consists of materials which can be recycled if
disassembled by a specialized company. Please observe the
local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
6
REMOTE CONTROL
Batteries for the remote control
• Open the battery compartment of the remote control and
insert 2 batteries, type AAA, R03 or UM-4 (preferably
alkaline).
Remove batteries if they are flat or if the unit is not going
to be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Speaker connections
The speaker terminals are click-fit connectors. Use them as
shown below.
• Connect the unmarked wire to the red terminal and the
marked (black) wire to the black terminal.
1
2
POWER SUPPLY
Mains
The type plate is located on the back of the unit.
1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does
not, consult your dealer or service organisation.
2 Connect the mains cable to the AC MAINS inlet and the
wall socket. This switches on the mains supply.
Safety information
To disconnect the unit from the mains completely, remove
the mains plug from the wall socket.
Place the unit on a solid surface. Make sure there is
sufficient space around the unit to prevent overheating.
This set complies with the radio interference
requirements of the European Community.
For users in the U.K.: please follow the instructions
on page 2.
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis