Maintenance; Troubleshooting; Technical Data - OHAUS Defender Series Base Bedienungsanleitung

EN-2
DxxxWx Bases
Install the load cell cable to an indicator using the wiring codes.
Note: When purchased as a Defender Series Scale, the DxxxWx base is already pre-wired to the indicator.
2.3 Selecting the location
To level the instrument, adjust the feet/leveling wheel so the bubble is centered in the circle of the level indicator. Be sure the
equipment is level each time its location is changed.

3. MAINTENANCE

3.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.

3.2 Troubleshooting

For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the
Ohaus office nearest you.

4. TECHNICAL DATA

The technical data is valid under the following ambient conditions:
Operating temperature: -10º C to +40 º C
Relative humidity: 10% to 90% relative humidity, non-condensing
Altitude: Up to 2,000m
Specifications:
MODEL
Capacity
Approved Resolution
Repeatability (std. deviation)
Linearity
MODEL
Capacity
Approved Resolution
Repeatability (std. deviation)
Linearity
Wiring Codes
FUNCTION
+ Excitation
- Excitation
+ Signal
- Signal
+ Sense
- Sense
Shield
.
D15HR
15 kg / 30 lb
D60HL
60 kg / 100 lb
OIML: 3000e,
NTEP: 3000d
WIRE COLOR
Green
Black
Red
White
Blue
Brown
Yellow
D30HR
30 kg / 60 lb
OIML: 3000e, NTEP: 3000d
1d
± 1d
D100HL D150HX
100 kg / 250 lb 150 kg / 300 lb
OIML: 3000e,
NTEP: 2500d
1d
± 1d
Defender Series Base
D60HR
60 kg / 150 lb
D300HX
300 kg / 600 lb
OIML: 3000e,
NTEP: 3000d