Network Control System Led Studio - EuroLite LSD-100 Bedienungsanleitung

4.2.2 Network control system LED Studio

Receiver interface (item 80503310), PCI sending card and control software LED Studio (item
80503130)
Control system consisting of receiver interface and PCI sending card with the control software LED Studio.
Contrary to the all-in-one network control system LEDShowT9, a computer with DVI output card and dual
display mode is required. The DVI output is connected to the sending card DVI input and then transmitted to
the receiver interface via the ethernet connectors.
For connecting LED display panels the receiver interface offers eight data signal outputs, each allows control
of 128 (width) x 16 (height) pixels. So one receiver interface can control 128 (width) x 128 (height) pixels in
total. A configuration with 256 (width) x 128 (height) pixels is also possible, however, results in a lower
grayscale resolution and data refresh rate. To built-up a large video wall with several LED display panels (up
to 1280 (width) x 1024 (height) pixels are possible), the receiver interfaces can be connected in series via
network cables.
System requirements:
• Windows 98/me/2000/NT/XP/Vista
• Free PCI slot
• Free serial communication port
• Video card with dual display mode and DVI output
Block diagram
4-4 Block diagram LED Studio
39/62 00049757.DOC, Version 1.1