Installation And Configuration Of The Control Systems; Control System Led Show T9 - EuroLite LSD-100 Bedienungsanleitung

7. INSTALLATION AND CONFIGURATION OF THE CONTROL SYSTEMS

Depending on the control system, the matching PC program must be installed before taking the display
panels into operation. This chapter is a quick guide for setting up both control systems. Please refer to the
corresponding user manuals for further information regarding installation, configuration and operation. The
manuals are included in the delivery and are also available for download on the internet: LED Show T9
http://download.showtechnic.de/?id=00049518, LED Studio http://download.showtechnic.de/?id=00049519.

7.1 Control system LED Show T9

7.1.1 Installation of the control software
Connect the display panels as described under 6.1 and connect the network interface to your computer. As
soon as an ethernet connection is established, the computer displays a dialog window in the lower right
corner of the screen (possibly limited connectivity is displayed, nevertheless, the ethernet connection is
sufficient for operation). Now install the control software LED Show T9 on your computer. For this purpose,
start the installation program Eurolite LED Show 9.9.1 Installer.EXE on the supplied CD and follow the
instructions of the installation program. In order to install the control software you must log on to your
computer as administrator or user with administrator rights.
Note: If your computer does not have a static IP address or if the IP address is allocated via DHCP
(Dynamic Host Configuration Protocol), the control software LED Show T9 automatically assigns the IP
address 192.192.192.111 and you can no longer access the network. The IP address remains assigned
even after closing the software so that you have to manually restore your original network settings in order to
reaccess the network. The problem can be avoided by assigning a static IP address to your computer or by
using a separate network card for operating the control system LED Show T9.
7.1.2 Configuration of the control software
The control software must be configured for use with the display panels, network card and network interface.
For this purpose, start the program and call menu item Control LED Admin.
7-1 Play window
7-2 Control panel
47/62 00049757.DOC, Version 1.1