EuroLite LSD-100 Bedienungsanleitung Seite 40

Connections of the PCI sending card
1. Status LEDs, red: power supply failure,
green: normal working mode
2. Gigabit ethernet outputs (RJ45 jacks) for
connection to a receiver interface
3. Power supply input (5 V DC), only used
if the sending
externally of a computer
Connections of the receiver interface
4-6 Receiver interface
Pixel control
per data cable
per network interface
4-5 PCI sending card
card is operated
128 (width) x 16 (height) pixels
128 (width) x 128 (height) pixels
4. RJ14 jack for connection to the RS-232
port on the computer via the supplied
adapter cable
5. DVI input for connection to the DVI
output on the computer via the supplied
DVI cable
1. Data signal outputs (15-pin DIN jacks)
1 to 8 for connection to the display
panels
2. Ethernet connection
input for connection to one of the
ethernet network
sending card or the previous receiver
interface via the supplied LAN cable
3. Ethernet connection
feed-through output for connection to
a subsequent receiver interface
4. 2-pin plug for connection to a display
panel for power supply (5 V DC) of
the receiver interface
40/62
(RJ45 jack),
outputs of the
(RJ45 jack),
00049757.DOC, Version 1.1