Cleaning; Accessories - JSP POWERCAP INFINITY Benutzerhandbuch

CLEANING:

The product should only be cleaned with a cloth lightly dampened with a mild detergent and non-agressive solution. Care must be taken to avoid
any liquids entering the motor/fan assembly or the filters. The elements of PowerCap
Pre-filter cover – wipe clean using a soft cloth, run under a tap and allow to dry.
Filter Case – remove and wipe down with a damp cloth.
Visor – refrain from rub rinsing, simply rinse and pat dry with a non abrasive cloth.
Helmet – wipe down with a damp cloth.
Face Seal Skirt – machine or hand wash in mild detergent at 30°C. Leave to dry naturally (Do NOT dry on a heat source or hang by skirt tabs
when wet). Do not allow water or other liquids to enter the inside of the drive unit or filters. Do not use solvents or abrasive cleaners on any part of
PowerCap Infinity .
® ®

ACCESSORIES:

Hearing protection can be added to the PowerCap
mounted ear defenders and the PowerCap
reduce the performance of PowerCap
Fitting the Sonis :
®
Remove the PowerCap Infinity
®
skirt from the harness (see Removing & Replacing the Visor) and disconnect the power cable from the battery box (see Battery and Airflow
Check). To remove the visor carrier, press the rear of the visor side arms towards the helmet shell and push forwards. (see Removing &
Replacing the Drive Unit and Visor Carrier Assembly).
1. Remove the visor carrier adaptors from the helmet shell. Inverting the helmet, push the adaptor blade towards the outside of the helmet and then
down. Insert a ball point pen or similar into the hole in the side of the helmet shell, at the same time press the adaptor blade whilst pulling
from shell as shown.
2. Fit the ear defender as the instructions supplied with the ear defender of your choice.
3. Once the ear defenders are fitted, slide the visor side arms into the slot on the ear defender helmet adaptor.
• Ensure that the face seal skirt is correctly attached as stated in Removing & Replacing the Visor.
• When donning the helmet, adjust the ear defenders as stated in user instructions supplied with the ear defender. Ensure that both the ear
defender and the PowerCap
by either or both products being severely reduced.
1
'BLADE'
Infinity by fitting the Sonis
® ®
Infinity have been designed to be compatible. Use of non-compatible hearing protection may
® ®
Infinity . Contact JSP Ltd to check compatibility of other hearing protection/accessories.
® ®
visor complete with the PowerCap
®
Infinity are correctly adjusted and comfortable. Failure to do so may result in the levels of protection offered
® ®
2
Infinity should be cleaned as detailed below:-
® ®
helmet mounted ear defenders. The Sonis
®
Infinity drive unit & visor carrier assembly. Unhook the sealing
® ®
3
18
range of helmet
®