Safety Precautions; Additional Industrial Safety Helmet Instructions - JSP POWERCAP INFINITY Benutzerhandbuch

SAFETY PRECAUTIONS:

PowerCap Infinity should be used in situations where the requirements for EN 12941:TH3, EN166:2001 and/or EN 397:2012 protection applies.
® ®
• This apparatus must not be worn in the hazard zone with the drive unit switched off.
• When switched off a build up of carbon dioxide and depletion of oxygen may occur.
• When switched off no respiratory protection is provided; this is considered to be an abnormal running condition.
• The apparatus should not be used in explosive atmospheres unless it is marked with the
• The apparatus should not be used in oxygen deficient atmospheres.
As required by European Health and Safety requirements, the user is advised that when in contact with the wearer's skin, the unit may cause
allergic reactions to susceptible individuals. If this is the case the wearer should leave the hazard area, remove the unit and seek doctor's advice.
• The apparatus is NOT suitable for protection against gases and vapours. • The apparatus should not be used in an atmosphere immediately
hazardous to life or health. • At high work rates the pressure in the device may become negative at peak inhalation flow. • Using the apparatus in
high wind velocities may affect filtering efficiency. • Only use genuine PowerCap
• Do not lift the visor whilst in the hazard zone. • Do not expose PowerCap
confined spaces or areas of poor ventilation. • Do not alter or modify the product in any way not approved by JSP Ltd. • Do not touch any moving
part. • Do not allow water or other liquids to enter the inside of the motor housing or battery compartment. • Care should be taken to avoid the
possibility of the power cable from the battery pack to drive unit becoming caught up in use.

ADDITIONAL INDUSTRIAL SAFETY HELMET INSTRUCTIONS:

Fitting and adjustment: Fit the helmet as described in the PowerCap
PowerCap Infinity must fit or be adjusted to the size of the user's head.
® ®
Use: The helmet is made to absorb the energy of an impact by partial destruction or damage to the shell or harness and even though such
damage may not be readily apparent, any helmet subjected to severe impact should be replaced. This helmet has been designed to protect
the wearer against electrical shocks by preventing passage of dangerous current through the body via the head. The helmet must be used with
other insulating protective equipment when working on low voltage installations. The user should check that the electrical limits of the helmets
correspond to the nominal voltage that is likely to be encountered during use. Accessories and/or replacement components are available with
fitting instructions from JSP.
Inspection and care of the helmet: The helmet is a complete system consisting of shell and harness. The helmet's useful life is affected by
many factors including the cold, heat, chemicals, sunlight and misuse. The helmet should be examined daily for obvious signs of cracking,
brittleness or damage to either helmet or harness. The user should be aware that there is potential risk of loss of protection due to ageing
and/or inappropriate cleaning. The effectiveness of the insulating properties of the helmet may be affected by the conditions of use. The date
of manufacture is moulded into the peak of the helmet. While the helmet is free from defects it is suitable for its intended purpose. If in any
doubt destroy the helmet.
Useful life: Under normal circumstances the helmet has a maximum life of 5 years from date of manufacture. Under no circumstances must a
component other than a JSP component be used on a JSP helmet.
mark.
Infinity filters supplied in pairs from JSP Ltd or its distributors.
® ®
Infinity to flames or sparks. • Do not use PowerCap
® ®
Infinity Donning section of this manual. For adequate protection
® ®
15
Infinity in
® ®