Changing The Temperature Unit; Troubleshooting; Cleaning, Storage, Disposal - Sanitas SFT 22 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für SFT 22:

Inhaltsverzeichnis

Verfügbare Sprachen

6.3 Changing the temperature unit

You can display the temperature in degrees Celsius (°C) or degrees Fahrenheit (°F). Press the button „ " to change the

measuring unit. Without releasing it press the „M" button to switch to the desired measuring unit. All saved values are

displayed in the new measuring unit.

7. Trouble shooting

Error

message Problem

Ambient temperature below 16 °C or above 35°C

(<60,8 °F, >95 °F).

The temperature measured is higher than 43 °C

(109,4 °F).

the temperature measured is lower than 34 °C

(93,2 °F).

Clean the sensor tip after every use. Use a clean cloth or cotton bud that can be moistened with disinfectant, alcohol or

warm water.

To clean the entire device, use a soft cloth slightly moistened with a mild soapy solution. Water must never get into the

device. If water gets into the device, remove the battery immediately. Only use the device again when it is completely dry.

Do not use any harsh cleaning agents.

Never immerse the device in water.

Solution

The ambient temperature must be between 16 °C and 35 °C

(60,8 °F, 95 °F).

Operate the thermometer only between the specified tempera ture

ranges. If necessary, clean the sensor tip. In the event of a repea-

ted error message, contact your dealer or customer service.

Operate the thermometer only between the specified temperature

ranges. If necessary, clean the sensor tip. In the event of a repeat-

ed error message, contact your dealer or customer service.

Inhaltsverzeichnis