Replacing Carbon Brushes; Optional Accessories - Makita DTS130 Bedienungsanleitung

Replacing carbon brushes

► Fig.12: 1. Limit mark
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove two screws then remove
the rear cover.
► Fig.13: 1. Rear cover 2. Screws
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit screw-
driver of slender shaft or the like.
► Fig.14: 1. Spring 2. Arm 3. Recessed part
Use pliers to remove the carbon brush cap of the car-
bon brushes. Take out the worn carbon brushes, insert
the new ones and replace the carbon brush cap in
reverse.
► Fig.15: 1. Carbon brush cap
Make sure that the carbon brush cap have fit into the
holes in brush holders securely.
► Fig.16: 1. Hole 2. Carbon brush cap
Reinstall the rear cover and tighten two screws
securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Screw bits
• Hook
• Plastic carrying case
• Various type of Makita genuine batteries and
chargers
• Bit piece
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
9 ENGLISH