Hifonics Brutus B3 series Bedienungsanleitung Seite 22

BXi1000D · BXi2000D · BXi3000D · BXi4000D
INTERCONNECTION EXAMPLE 1 Subwoofer with a Single-Voicecoil
MASTER
BATT +12V REM GND
FUSE
POWER INPUT
INTERCONNECTION EXAMPLE 1 Subwoofer with a Dual-Voicecoil
MASTER
BATT +12V REM GND
FUSE
POWER INPUT
Subwoofer Voice Coil 1
INTERCONNECTION EXAMPLE 2 Subwoofers with Single-Voicecoils
MASTER
BATT +12V REM GND
FUSE
POWER INPUT
Subwoofer 1
1 – 8 Ohms
INTERCONNECTION SUBWOOFER
• Connect the Subwoofer terminals with the speaker outputs (SPEAKER OUTPUT + / -) of both amplifiers by using appropriate wires.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
• Ensure by any means, that the total impedance load of subwoofer is not lower than described above.
• Too low impedance cause high temperature and will shut down the amplifier operation.
MASTER/SLAVE Link
like described on page 21.
+ + – –
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
SPEAKER OUTPUT
Subwoofer
2 – 8 Ohms
MASTER/SLAVE Link
like described on page 21.
+ + – –
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
SPEAKER OUTPUT
1 – 8 Ohms
MASTER/SLAVE Link
like described on page 21.
+ + – –
LOGO
BADGE
PROTECT
BRIDGE
BLUE
WHITE
SPEAKER OUTPUT
BATT +12V
FUSE
The Impedance may not
be lower than 2 ohms.
BATT +12V
FUSE
Subwoofer Voice Coil 2
1 – 8 Ohms
The subwoofer voice coil on the SLAVE amp needs
to be connected with a converse polarity.
BATT +12V
FUSE
Subwoofer 2
1 – 8 Ohms
The subwoofer on
the SLAVE amp needs
to be connected with a
converse polarity.
25
22
SLAVE
+ + – –
REM GND
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
SPEAKER OUTPUT
POWER INPUT
SLAVE
+ + – –
REM GND
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
POWER INPUT SPEAKER OUTPUT
SLAVE
+ + – –
REM GND
LOGO
BADGE
PROTECT
BRIDGE
BLUE
WHITE
POWER INPUT SPEAKER OUTPUT