Interconnection Example Master/Slave-Mode - Hifonics Brutus B3 series Bedienungsanleitung

BXi1000D · BXi2000D · BXi3000D · BXi4000D
INTERCONNECTION EXAMPLE Master/Slave Mode
Remote wire REM
MASTER
Switch setting = MASTER
1.
BXi 4000D
1x 2000 Watts
Remote wire REM
BATT +12V REM GND
FUSE
POWER INPUT
INTERCONNECTION MASTER
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
• Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
• Connect the RCA jacks SLAVE IN/OUT of the MASTER amp with the RCA jacks SLAVE IN/OUT of the SLAVE amp with appropriate
high-value RCA cables.
• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use therefore cable with a minimum profile section of 0,5 mm
• Connect the PROTECT BRIDGE port of the MASTER amp with the PROTECT BRIDGE port of the SLAVE amp with the enclosed
PROTECT BRIDGE wire.
INTERCONNECTION SUBWOOFER
• Attend page 22.
SETTINGS MASTER
• The MODE switch should be in MASTER position.
Attend therefor the information of LOW PASS, SUB SONIC, PHASE, LEVEL, SUB BOOST, FREQ RANGE, Q-CONTROL and BASS
REMOTE on page 20.
SETTINGS SLAVE
• The MODE switch must be in SLAVE position.
In the SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
Connect the bass remote
controller and the remote terminal
on the amplifier (MASTER)
with the enclosed cable.
SLAVE IN/OUT
SLAVE MASTER
MODE
+ + – –
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
SPEAKER OUTPUT
2
1. Connect Stereo RCA output (L/R
or SUB OUT) of the headunit with the
LINE INPUT CH1/2 of the MASTER amp
2. Connect Stereo RCA output (SLAVE IN/OUT)
of the MASTER amp with the SLAVE IN/OUT
of the SLAVE amp
2.
BXi 4000D
1x 2000 Watts
Remote wire REM
Protect Bridge wire
FUSE
.
21
SLAVE
Switch setting = SLAVE
SLAVE IN/OUT
SLAVE MASTER
MODE
+ + – –
BATT +12V REM GND
LOGO
BADGE PROTECT
BRIDGE
BLUE
WHITE
POWER INPUT SPEAKER OUTPUT