Technical Features; Arrangement For Installation - Jacuzzi city spa Vorinstallationsblatt

It is the responsibility of the installer/owner to ascertain
compliance with specific local regulations prior to installa-
tion. Jacuzzi Europe S.p.A. gives no guarantee in this respect
and declines all responsibility regarding the compliance of
the installation performed.

Technical Features

1; 2) comes with a 2 Hp pump and a recircula-
City™ Spa (
tion pump.
City™ Spa is equipped with a cartridge filter that ensures excel-
lent water filtering (filtering surface: 4.6 m
City™ Spa is also available with perimeter panels of the follow-
ing types:
- wood panels (--> Sasha)
(only for interior installations)
- wood panels (with teak finishing)
(for both indoor and outdoor installation).
- composite wood panels
(for both indoor and outdoor installation).
2) customised panels, on which coatings with thickness
- (
of a couple of millimetres may be applied. If you want to apply
thicker coverings (mosaic, tiles, etc.), you can partially mill the
unfinished panel.
Maximum absorption of the system
• 2 K
VERSION WITH HEATER W
Power supply (x)
· electric heater + hydromassage + filtering
Voltage Hertz Ampere
220-240 ~ 50/60 17,5 (k)
• 1,5 K
VERSION WITH HEATER W
Power supply (x)
· electric heater + filtering
Voltage Hertz Ampere
220-240 ~ 50/60 8 (k)
(k): at 230 V - (j): absorbed power
(x): see "Electrical preparations"
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table).
2 ).
Total consumption
kW
4,0 (j)
Total consumption
·
only hydromassage
kW
1,8 (j)
Weights
Net weight
kg
~ 220
support area
2
m
~ 2,25
User safety
If installed by qualified personnel in compliance with the in-
structions in the enclosed installation manual, the system does
not present any risks for the user. However, safety is also contin-
gent upon appropriate use, according to the provisions in the
respective manual, while the user must delegate the operations
described in the installation manual to qualified personnel.
It is important to make sure that personnel tasked to install
or manage the system are qualified as per legal requirements in
effect in the country where installation is carried out.
For special maintenance operations and/or repairs, you should
always contact authorised Jacuzzi® service centres and use only
original spare parts.

Arrangement for installation

City™ Spa requires the following plumbing connections (ar-
ranged as in
- B: spa drainage.
Audio System
(optional)
- C: connection of overflow; to be made in the field, after drilling
kW
a hold in the bottom of the support base, depending on the type
0,25 (j)
of installation.
The customer must make provisions for a ground drainage point
of suitable dimensions and that can be inspected for any clean-
Audio System
ing that may be required.
(optional)
kW
ATTENTION: Before preparing the ground drainage
0,25 (j)
point, consult the local authority for the regulations
that control the drainage of chemically treated water.
If installation is made indoors, it is advisable to provide a
drain system under the support area of the spa which is con-
nected to the main drain, connecting the main drain also to
the fitting present on the base (
Considering the large amount of water in the spa, this pre-
caution is advisable should there be accidental water leak-
age (also see
13 13
average fill water volume
MAX
litres litres
~ 470 ~ 570
concentrated load
on support area
2
kg/m
~ 350
1 and 3):
3, det.B3).
8, det.5).
Total max. weight
kg
~ 790