Bartscher 600 Serie Bedienungsanleitung Seite 22

protection switches available on the market have a current tolerance of less than 50%;
therefore, a suitable switch should be chosen.
Connect only one single appliance to each switch.

In some cases, after long periods of inactivity or with a new installation, it is possible that the
appliance trips the safety switch when it is turned on. The reason for this is usually moisture in the
insulation. The problem can be solved by a short pre-heating that bypasses the safety thermostat.
ATTENTION! All the parts protected and sealed by the manufacturer can not be regulated
by the installer if not specifically indicated.
Chip scuttle (fig. 5 – p. 3)
In order to switch on the appliance, proceed as follows:
- Turn the knob (1) of the power regulator;
- At the same time the lamp (2) will light on to mark the presence of tension;
- According to the knob position, the heating element carries out a cycle of turn-on and turn-off,
in order to keep the radiating temperature even. The larger the area to be seen on the knob, the
longer the turn-on time if compared to the turn-off time. Between the limit of the maximum
area and the indicator the plate always works at the maximum power available;
In order to switch off the appliance turn the knob (1) to the 0 position.
The heating element is provided with an automatically rearmed safety thermostat, which is activated
at a preset temperature, so to avoid the temperature to increase dangerously and out of control.
ATTENTION! Use the appliance only under observation. Never let the appliance be heated if
it is empty.
During the normal functioning of the appliance the area near the heating element (3) can
reach high temperatures; this area is marked with a sticker attached on the radiating head.
During the appliance normal functioning never touch the radiating head.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
Some problems and possible solutions
Problem
No heat
No indicator light
Slow and/or insufficient heat
INSTRUCTIONS FOR USE
-
Check the power supply
- Check the condition of the heating element
-
Check the energy regulator
- Check the power supply
-
Check the light bulb
- Check the setting of the energy regulator
-
Check the condition of the heating elements
- Check the quantity of food to be cooked
Pag. 21/31
Possible solution