Door Reversibility - Electrolux ern 29850 Gebrauchsanweisung

The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Door reversibility

The appliance is supplied with the right or
left door opening. To change the opening
direction of the door proceed as in the
following instructions before installing it.
1. Unscrew the upper pin and remove the spacer
2. Remove the upper door and the upper hinge pin.
3. Remove the hinge cover (A). Unscrew the pins
(B) and spacers (C). Fit the hinge cover (A).
4. Unscrew the lower pin and refit it on the opposite
side.
5. Refit the lower door.
6. Refit the pins (B) and the spacers (C) on the
middle hinge on the opposite side.
7. Refit the upper door , the hinge pin and the
spacer on the opposite side .
Instructions for totally built-in appliances
Building-in instructions
Dimensions of housing
Height 1780 mm
Depth 550 mm
Width 560 mm
For safety reasons, minimum ventilation must be as
shown in Fig.
Attention: keep ventilation openings clear of
obstruction.
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
50 mm
D567
C
B
A
min.
2
200 cm
min.
200 cm
2
49