Commissioning - Monuments IRON III Montage- Und Gebrauchsanweisung

• Attach the two wall mounting brackets to the rear of the sauna heater using the 6 mounting screws M4. Ensure that
the sides with the keyholes for attachment are always in the right position toward the outside of the sauna heater.
• Now you can hook the keyholes of the sauna heater onto the screws that are screwed into the cabin wall and then
secure on the wall fixtures with the two locking screws. (Fig. 8).
• Connect the power cable to the mains. Please pay attention to the local safety norms and applicable regulations.
Commissioning / First use
Rotate the timer knob in order to switch the sauna heater on. By rotating the switch you can determine the desired heating
time - align the arrow on the rotating knob with the corresponding time setting. The maximum possible heating time is
4 hours. After this time the heater will switch off automatically.
In order to switch the heater off manually rotate the timer knob to position „0".
28
Timer knob
Thermostat
0
max.
min.
EN
Upper mounting screws
Keyhole shape holes
for wall mounting
securing screw
Fig. 8
Fig. 9