Intended Use; General Information - Monuments IRON III Montage- Und Gebrauchsanweisung

Dear customer
You have purchased a high-quality technical device
with which you will have years of sauna fun. This sauna
heater was designed and inspected according to the
current European safety standards and manufactured
at the factory in accordance with the quality manage-
ment standard DIN EN ISO 9001:2008.
This detailed installation and operation manual has
been prepared for your information. Please observe
in particular the important notes and the information
on electrical connection.
We wish you exhilarating recreational experience and
lots of fun with your sauna!

Intended use

This sauna heater is exclusively intended for the
heating of sauna cabins in combination with an ap-
propriate control unit.
Any other use over and above the intended purpose
is not considered as appropriate use! Compliance
of the standard operation, maintenance and repair
conditions is also an element of appropriate use.
The manufacturer cannot be held liable for devi-
ating, unauthorized alterations and any resulting
damages: the initiator of these changes bears the
full risk.

General information

Please check whether the unit has arrived in perfect
condition. Any transport damages should be imme-
diately reported to the freight forwarder delivering
the goods or you should contact the company that
shipped the goods.
Please note that you will only be able to achieve an
optimum sauna climate if the cabin with its air intake
and ventilation, the sauna heater and the control unit
are aligned to each other.
Please observe the information and stipulations made
by your sauna supplier.
Sauna heaters heat up your sauna cabin using heated
convective air. Here, fresh air is drawn in from the air
intake which, when heated, rises upwards (convec-
tion) and is then circulated within the cabin. Part of
the used air is pushed out through the vent in the
cabin. This creates a typical sauna climate which can
achieve temperatures of approx. 110°C measured
directly under the ceiling of your sauna, dropping in
temperature to approx. 30-40°C towards the floor. It
is therefore not unusual to measure temperatures of
110°C on the temperature sensor hanging over the
heater, whilst the thermometer hanging on the sauna
wall, approx. 20-25 cm under the cabin ceiling, only
indicates 85°C. The bathing temperature generally lies
between 80°C and 90°C in the area of the upper bench
when the temperature is set to maximum.
Please note that the highest temperatures are always
generated over the sauna heater and that the temper-
ature sensor and the safety limiter must be mounted
there in accordance with the control unit installation
instructions.
When heating up for the first time, you may notice a
slight smell caused by evaporating lubricants used
in production processes. Please ventilate your cabin
before beginning your sauna bath.
EN
19