• Attach the enclosed screws in the centre of the cabin wall above the air intake as shown in Fig. 3. There must be a
clearance of approx. 2 mm between the screw head and the cabin wall in order to attach the sauna heater.
• An installation template with position of mounting screws is printed on the packaging of the heater. You can use this
as a drilling template.
Air intake
• First remove the transport locks by releasing the two lower screws on the rear (see Fig. 4) and remove the lock by
pulling downwards.
Remove screws
26
Transport protection
EN
Fig. 3
Fig. 4