Overheat Protection - Silvercrest SKF 2300 B2 Bedienungsanleitung

Overheat Protection

GB
16
In a case of overheating, the heat protection function switches the appliance off .
This can happen if there is no, or not suffi cient, oil or fat in the deep fryer or
when solid cooking fats are being molten in the appliance.
With solid cooking fats the heating element cannot disburse the heat created fast
enough.
If the heat protection function has switched the appliance off , please proceed as
follows:
1) Allow the appliance to cool down.
2) Leave the oil or fat to cool (the fat should just be liquid).
3) Open the appliance lid by pressing on the lid release button 6.
4) Remove the frying basket 3.
5) Remove the control/heating element 5.
6) Place the operating/heating element 5 at a clean and dry location.
7) Carefully press the reset button t on the rear side of the operating/heating
element 5 with a small pointed object.
The appliance can now be used again.
SKF 2300 B2