Inhaltsverzeichnis
Werbung
Anleitung_IHS_2000_SPK7:_
GB
6.2 Setting the heat output (Fig. 1):
The heat output is set by pulling the cord of the pull
switch (3) once or repeatedly. The selected heat
output can be read off the display (2). If the
maximum heat output is selected and the pull switch
is activated once more, the appliance shuts down.
6.3 Display of heat settings
No heat output = Display indicates "0"
Minimum heat output = Display indicates "1"
Medium heat output = Display indicates "2"
Maximum heat output = Display indicates "3"
7. Maintenance and cleaning
Maintenance and repair work may only be carried
out by an electrical servicing contractor or ISC
GmbH.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or ISC GmbH in
compliance with the relevant regulations.
Important: Disconnect the mains lead before
cleaning – danger of electric shock.
Use a damp cloth to clean the casing.
Never use combustible cleaning agents.
To remove dust on the reflector and heating
elements, use a brush with long soft bristles.
In cases of very stubborn dirt the appliance should
be cleaned by a professional.
8. Storage
The radiator has to be stored in a dry place, covered
if possible.
9. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10
07.04.2008
13:06 Uhr
Seite 10
Werbung
Inhaltsverzeichnis
