Oase ProMax Garden Automatic series Gebrauchsanleitung Seite 18

• During operation, sensors monitor the
water flow and water pressure to pre-
vent the pump, for example, from run-
ning dry. Depending on the event (in-
sufficient flow rate or water pressure
below 1.5 bar) the pump changes to
the operating state stand-by or switch-
es off.
• The lit or flashing LEDs in the ON/OFF
button indicate the respective operating
status. (→ Operating status and atten-
dant LED displays)
Operating modes
Mode A (delivery state):
• Connect the pump to the power supply.
– When all LEDs are lit, the pump is
ready for operation
(→ Operating status and attendant
LED displays)
• Switching on: Press the ON/OFF but-
ton for less than 3 s.
• Switching off: Press the ON/OFF but-
ton again.
Operating status and attendant LED displays
LED
Blue Yel- Red
low
  
  
  
  
  
  
  
18
(stand-by).
Operating status
Flashing fre-
quency
– Pump is operational.
– No malfunctions, pump is
running.
4× per second No malfunctions, the pump
will soon switch to standby.
– No malfunctions, the pump is
in standby.
– Pump is not taking in water.
1st stage - dry run protection
1× per second Pump is not taking in water.
• 2nd stage - dry run protec-
tion
2× per second Pump is not taking in water.
• 3rd stage - dry run protec-
tion
ProMax Garden Automatic 3500/4000/5000/6000
Mode B:
In this mode the pump can, for example,
be switched on and off by a timer.
• The pump switches on as soon as it is
connected to the power supply.
Changing the mode
• Press the ON/OFF button for at least
10 s.
– Mode A active: The LEDs blue, yel-
low and red light up once.
– Mode B active: The LEDs blue, yel-
low and red flash 3 times.
Switching on the pump following a
malfunction
The LEDS yellow and red are lit when the
pump switches off due to a malfunction.
• Press the ON/OFF button for at least
3 s, but not longer than 6 s to switch
the pump on again.
User
Switch on the
pump.
Wait
Wait
Wait