THERMEx INTEGRATA Handbuch Seite 27

Remote control
Turn on/off lights:
Press once: Operation light
Press three times: Decor light
Timer button. If you select this feature, the engine will stop automatically after
15 minutes. The light on the receiver station in the ceiling will be lit if the timer is
in use.
Turn off engine.
Start engine and fan speed selector (light indicates selected speed).
Start/stop turbo function (light indicates when function is selected).
.
Reciever
Timer button. The light on the receiver station in the ceiling will be lit if the
timer is in use.
Light indicates selected speed
Start/stop turbo function (light indicates when function is selected).
Signal light
The light for grease filter cleaning is in the receiver station in the ceiling.
After a time interval (approx. 30 hours) the light will indicate that the grease filters
need to be cleaned. Resetting light: Hold down the turn off button for approx. 15 seconds
until the light is switched off.
Extra Functionings:
Controlling of habitation ventilation:
Via the control panel the user has the possibility of programming interval induction. One can
choose between 0, 5, 10 or 15 minutes' ventilation with an hour's interval. First time is started an
hour after activation. Interval induction for room ventilation is always at lowest speed.
Programming of Interval Induction:
First stop the ventilation on the off-button. Press down the timer button. After about 2 seconds a
beep is heard, then let go of the button and the timer diode is on.
Push down the turbo button to change the time. Speed diode 1 alight = 5 minutes. Speed diode 2
alight = 10 minutes. Speed diode 3 alight = 15 minutes.
If none of the three diodes are alight the function is disconnected. End by pushing the off-button.
The speed diode for the chosen time is blinking, indicating that the interval induction is on.
NB The canopy can always be used normally even though the interval induction is on.
Press twice: Operation and decor light
Press four times: Turn light off