Optional Accessory; Optional Accessories - Makita TD022D Betriebsanleitung

NOTE: Use the proper bit for the head of the screw/
bolt that you wish to use.
NOTE: When fastening M5 or smaller screw, carefully
adjust rotation angle on the switch so that the screw
is not damaged.
NOTE: Hold the tool pointed straight at the screw.
NOTE: If the impact force is too strong or you tighten
the screw for a time longer than shown in the figures,
the screw or the point of the driver bit may be over-
stressed, stripped, damaged, etc. Before starting your
job, always perform a test operation to determine the
proper fastening time for your screw.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3. Bolt
• Even though the torque coefficient and the
class of bolt are the same, the proper fasten-
ing torque will differ according to the diame-
ter of bolt.
• Even though the diameters of bolts are the
same, the proper fastening torque will differ
according to the torque coefficient, the class
of bolt and the bolt length.
4. The manner of holding the tool or the material
of driving position to be fastened will affect the
torque.
5. Operating the tool at low speed will cause a reduc-
tion in the fastening torque.
Using the tool as a hand screwdriver
► Fig.10
Switch off the tool.
Move the lock lever to the locked position
Turn the tool.
NOTICE:
Use the tool with a fastening torque less
than 12.5 N•m.
NOTICE:
Do not use the tool for work requiring
excessive force, such as tightening bolt M10 or bolts
greater than M10 or removing rusted screws.
NOTE: This use is convenient for checking the
screwdriving.
Using holster

Optional accessory

CAUTION:
driver bit/drill bit from the tool.
CAUTION:
comes to a complete stop before placing it in the
holster.
CAUTION:
locked position before using the holster.
CAUTION:
the tool deeply and be sure that the tool is held
securely.
1. Thread a waist belt or similar through holster holder.
► Fig.11: 1. Holster holder 2. Waist belt
2. Set the lock lever in the locked position and insert
the tool into the holster firmly.
► Fig.12
MAINTENANCE
CAUTION:
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
.
OPTIONAL
ACCESSORIES
CAUTION:
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita Service Center.
• Driver bits
• Socket bits
• Bit piece
• Soft carrying case
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
8 ENGLISH
When using the holster, remove a
Turn off the tool and wait until it
Be sure to set the lock lever in the
When using the holster, insert
Always be sure that the tool is
Never use gasoline, benzine, thinner,
These accessories or attachments