Control Panel - Faber Fabula BK 90 RB Bedienungsanleitung

USE
Button Function
A The button only works when the door is open.
Press Briefly = Turns the Lights On/Off at maximum intensity.
Press and hold for 2 Seconds = Turns the Courtesy Lights
On/Off.
B Only works with the Door Open.
Press briefly = Activates/Deactivates Delay mode, causing auto-
matic shutdown of the Motor and the Lighting system from any
speed with a 15' delay. It is disabled by pressing the same button
again, turning the motor off or closing the door.
Works both with the Door Closed and Open.
Press and hold for 2 Seconds = With the filter alarm triggered the
Filter Alarm is Reset. These indications are only visible when the
motor is turned off.
Works both with Door Closed and Open with Motor + Lights =
Off.
Press and hold for 4 Seconds = Enables/disables the Keyboard
lock.
C Only works with the Door Open.
Press briefly = Activates speed four.
Only works with the Door Open.
Press and hold for 2 seconds = Enables/Disables the Intensive
speed. This speed is timed to run for 6 minutes. At the end of this
time the system will return to the speed set previously.
It is disabled by pressing the same button again, turning the motor
off or closing the door.
D Only works with the Door Open.
Activates speed three.
E Only works with the Door Open
Activates/Deactivates speed two.
F Only works with the Door Open.
Press briefly = Activates/Deactivates speed one.
Door Open or Closed
Press and hold for 2 Seconds = Enables/Disables the Activated
Charcoal Filter Alarm with the Motor turned off and no Filter
Alarm triggered.
G Door Open
Press briefly = Turns the Motor off.
Door Open or Closed.
Press and hold for 2 Seconds with Motor and Lights Off =
Enables/Disables the Remote control.
H Door Open = Closes the Door + Lights and Motor Off
Door Closed = Opens the Door + Lights and Motor On.
Warning: If the Door remains partially open for any reason, press
the Button to complete the opening or closing cycle.
EN

Control panel

LED button
LED Button B+ Button for the set Speed are lit.
Fixed LED button:
Indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
Flashing LED button:
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. The
alarm is triggered after the Hood has been in
operation for 200 working hours.
All the LED buttons flash twice. During the Lock
the LED buttons light up in sequence.
Fixed LED button.
Flashing LED button.
Fixed LED button.
Fixed LED button.
Fixed LED button.
LED button B flashes twice = Activated Charcoal
filter Alarm Activated.
LED button B flashes once = Activated Charcoal
filter Alarm Deactivated.
LED button goes out.
LED button G + F flashes twice = Remote control
Enabled.
LED button G + F flashes once = Remote control
Disabled.
3 33