Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Strimmer/3-Section Cutting Blade Attachment; Cleaning The Air Filter; Spark Plug; Carburettor - Zipper ZI-GPS182J Betriebsanleitung

Gartenpflege-set
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

14.1.3 Cleaning the strimmer/3-section cutting blade attachment

Remove stuck cuttings.
Keep the 3-section cutting blade sharp to facilitate your work.

14.1.4 Cleaning the air filter

Contaminated air filters reduce the engine performance due to low air
supply to the carburettor.
Regular inspection is essential. The air filter (I) must be inspected
after every 25 hours of operation and cleaned if necessary.
The air filter must be checked more frequently if the air is dusty.
1.) Remove the cover of the air filter housing (16).
2.) Remove the air filter (I).
3.) Clean the air filter (I) by tapping or blowing it out (with
compressed air).
4.) Assembly takes place in the reverse order.

14.1.5 Spark plug

1.) Pull off the spark plug connector (10).
2.) Unscrew the spark plug using the spark plug wrench
supplied.
3.) Assembly takes place in the reverse order.
Electrode gap = 0.6 mm (distance between the electrodes between which the ignition spark is
generated). Check the spark plug for contamination after the first 10 hours of operation and clean it
with a copper wire brush if required. Afterwards, service the spark plug after every 25 hours of
operation.

14.1.6 Carburettor

Carburetor adjustments should be carried out only by trained specialist personnel!

14.1.7 Adjusting the throttle cable

If the appliance no longer reaches maximum speed after a while and all
other causes as described in the "Troubleshooting" section have been
ruled out, this may mean that the throttle cable needs to be adjusted.
To adjust the throttle cable, screw in the screw (H) or the adjusting
screw (H1) as well as the lock nut (H2) correctly.

14.1.8 Lubricating the gears

To do this, undo the screw (D) to press the gear grease into the gear
housing.
After filling the gearbox, close the lubrication hole with the screw (D).
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
NOTICE
MAINTENANCE
40

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis