Safety Instructions - Zipper ZI-GPS182J Betriebsanleitung

For the branch saw applies:
 The branch saw no use for felling trees, saplings or bushes.
 The branch saw no use for cutting building materials and plastics.
 The branch saw is suitable only for private use in the home and hobby gardens.
 The branch saw is not suitable for forestry work (removing branches in the forest).

11.2 Safety instructions

Missing or non-readable security stickers have to be replaced immediately!
To avoid malfunction, machine defects and injuries, read the following security
instructions!
The locally applicable laws and regulations may specify the minimum age of the operator and limit
the use of this machine!
 Use the machine only in good enough light to allow a safe operation can be guaranteed.
 In tiredness, decreased concentration or under the influence of alcohol or drugs, the work on
the machine is prohibited!
 Caution in slippery conditions - slip hazard - risk of injury. When working, robust and non-slip
footwear. Slides / stumble / traps are a major cause of serious injury or death.
 The machine may only be operated by trained personnel.
 Unauthorized persons, especially children and not trained personnel must be kept away from
the running machine!
 If you pass the machine to third, these instructions must be attached to the machine.
 Before each use, the reliability of the machine is to be checked (tightness of the cutting tool, the
proper function of the throttle lever)
 Danger of burns! During the operation flow of hot exhaust gases and engine parts such as the
carburettor and engine become hot.
 Never place a hot brush cutter in dry grass or other easily flammable materials.
 After the operation, the machine must cool down. Otherwise there is an imminent risk of burns
 WARNING: Gasoline is highly flammable!
 Smoking and open flames are prohibited during refuelling. Do not refuel when the engine and
carburettor are still very hot.
 Refuel only outdoors or in a well ventilated area.
 Avoid contact with skin and clothes (fire hazard).
 Check after refuelling tank cap and check for leaks.
 Start the engine at least 3 meters from the tank location.
 Spilled fuel is wipe immediately.
 Work attentively, safety conscious and always be fully aware safe stand when working! Caution
on uneven work surfaces and work surfaces with a slope!
 Regular breaks reduce the security risk to loss of control due to fatigue. Change the working
position over again.
 Avoid abnormal posture.
 At idle, the blade should not rotate!
 The maximum shaft speed must not exceed the specified speed. Checked settings!
 No other person shall remain within 15m!
 This distance also adhere to things! Danger of damage!
 Solid objects, stones, metal parts, or the like can be thrown out - risk of injury!
 Use personal safety equipment: ear protectors, safety goggles, safety shoes and safety helmet
when working with the machine
 Never leave the machine running unattended! Before leaving the working area switch the
machine off and wait until the machine stops.
 Switch off the machine before maintenance or adjustment.
 Storage always with an empty tank in a safe place.
 Do not grab in the cutting tool while it is rotating.
 Take care that you do not get under the cutting tool!
 Always use the correct cutting tool for the work to be done.
 Do not operate in an enclosed or confined areas.
 Exhaust contains poisonous carbon monoxide. The exposure can cause unconsciousness and
death.
ZIPPER MASCHINEN GmbH
ZI-GPS182J
www.Zipper-Maschinen.at
SAFETY
29