User Instruction - Vitek Glutton VT-1810 R Betriebsanweisung

sharply decreased, switch off the vacuum
cleaner immediately and check the exten-
sion pipe and flexible hose with respect to
blockage. Switch off the vacuum cleaner and
unplug it, remove the blockage and then con-
tinue the cleaning.
• Do not use the vacuum cleaner near heat-
ed sources, near an ash tray and in places
where flammable liquids are stored.
• Insert the plug in the socket only with dry
hands.
• Before cleaning take away all sharp objects
from the floor in order not to damage the
dust-collecting box.
• While extracting the plug from the socket
hold it by the plug, do not pull the net ca-
ble.
Preparation for use
Fully unpack the vacuum cleaner. Before
switching on make sure that the voltage of the
vacuum cleaner corresponds to the net volt-
age. Always unplug the vacuum cleaner and
pull the plug out of the socket while changing
attachments and while preventive measures.
USAGE OF THE VACUUM CLEANER
• Make sure that the dust-collecting box (17
or 24) and the inlet filter (19) set properly.
• Insert the flexible hose tip (6) into the air in-
let (8) until bumping. To take off the flexible
hose press clamping buttons and take the
flexible hose tip out (6). (Pic.1)
• Attach extension pipe (2) to the flexible
hose handle (4). (Pic. 2).
Attaching of the extension pipe and at-
tachments
- Attach extension pipe (2) to the flexible
hose handle (4). (Pic. 2).
- Extent the bottom of the extension pipe for
a needed length, pressing first the clamp
button. (Pic. 3).
Floor and carpet brush (1)
• Connect the brush (1) with the extension
pipe (2) (Pic. 4).
Vt-1810.indd 5 Vt-1810.indd 5
• Set the switch on the brush at a required
position (depending on the surface type for
cleaning) (Pic. 5, 6).
Slit-type attachment (25)
For cleaning of radiators, slits, corners and
between sofa pillows.
Attach the slit-type attachment (25) to the ex-
tension pipe (2) or to the flexible hose handle
(4).

USER INSTRUCTION

Before operating extend the net cable (20) for
a needed length and insert the plug into the
socket. Yellow mark on the net cable notices
about max. cable length.
Do not extend the net cable beyond the red
mark. Always switch the vacuum cleaner on
only with the set dust-collecting box (17 or 24)
and filter (19).
• To switch the vacuum cleaner on press the
button ON/OFF (14).
• To coil the net cable press the button (11),
hold the coiling cable with your hand in or-
der to avoid whipping and damage.
• While work you can regulate suction force
by moving power regulation handle (12),
and by suction force adjuster (3), which are
on the extension hose handle (4) (Pic. 2).
CARE
Always use the vacuum cleaner only with the
set dust-collecting box (17 or 24) and inlet fil-
ter (19).
If there are no dust-collecting box (17 or 24)
and inlet filter (19) the electric motor of the
vacuum cleaner may fall out and this case is
not under warranty.
• Switch off the vacuum cleaner by ON/OFF
button (14) and unplug it.
• Press clamping buttons of the extension
hose tip (6) and detach it from the case of
the vacuum cleaner.
• Press the clamp of the dust-collecting box
(7) and open it.
• Press the frame clamp (15) of the dust-col-
lecting box and take out the frame (16),
5
ENGLISH
04.12.2006 16:07:35 04.12.2006 16:07:35