Technical Specifications - CMS Dental FlashMax P3 460 4W Gebrauchsanweisung

1. Technical description
The FlashMax P3 light is a medical
device, class I, in compliance with MDD
(Medical Devices Directive) section IX.
The light must only be used in dental
clinics by dental personnel, and only
for designated purposes. The product
is classified as an electronic medical
device electric class II according to DS/
EN 60601-1:1998. The product is classified
as a class 2 LED product according to
EN 60825-1:2001 Ed1.2.
CMS Dental declares that the product
described in this manual complies with
the above mentioned standards.
The FlashMax P3 light consists of a
hand piece, a docking station and an
external power supply. Disposable
covers and tips protect against cross
contamination.
WARNINGS
1. Do not expose directly into the eyes,
or look directly at the emitted light.
2. Eyewear protection should be used.
3. Medical electronic equipment is
sensitive to electromagnetic fields.
Portable and mobile high frequency
communication devices may interfere
with medical devices. In order to
maintain proper operation, follow
instructions in this manual.
4. Use of the light without a tip may
cause overheating of the tissue if the
light is used close to the gingiva.
4
5. Extended use cause tip and cover
to be hot and may cause slight
burning sensation of mucosa, if
touched.
6. Do not reuse covers or tips as this
may cause cross contamination.
7. If the light beeps every 2 s when
placed in docking station, it is a warning
that the charging voltage is 6 V or
higher, i.e. a wrong power supply is
being used.

1.1 Technical specifications

Power supply
Input power 100–240VAC, 50/60Hz
Output power 5.0VDC, 1.0A
Battery
Battery type LiFePO
Nominal voltage 3.2V
Nominal capacity 1.200mA
Re-charging time 2 hours
User capacity approx. 500 seconds
LED diode
Output intensity 5.000-6.000 mW/cm
Wavelength 450-470nm (85%),
peak 460nm
Other
Operation mode Intermittent.
No continous use over 1
minute to prevent over
heating
1.2 Environmental conditions for
intended use
Temperature range +10˚C to +40˚C
Humidity range 30% to 75%
Atmospheric 70kPa to 106kPa
pressure range (0.7 bar to 1.06 bar)
IP class 2X
4
2