Silvercrest SWKS 2200 C1 Bedienungsanleitung Und Sicherheitshinweise Seite 14

SilverCrest SWKS 2200 C1

Unwind the power cord (7) underneath the base (5).

Place the base (5) on an even, non-slip and dry surface. Note that the power cord (7) must be
fed through one of the notches provided on the underside of the base (5) to ensure stable
positioning.
WARNING
If the power cord (7) is not fed through one of the notches provided on the
underside of the base (5), the base (5) and kettle (4) will not be stable. The
movement of the boiling water could make the kettle (4) tip over causing severe
damage to property and personal injury!

Open the lid (10) by pressing the lid release button (9).
"Minimum fill level" indicator
The minimum water fill level is 0.5 litres.
This low level is not visible on the outer
water level indicator (3).
A special mark indicating the exact
minimum fill level can therefore be seen
inside the kettle (4) while filling with
water. This mark inside the kettle (4) is
visible when the lid (10) is open.

Fill the kettle (4) with drinking water, at least up to the "MIN 0.5L" mark inside and up to the
"1.7L MAX" mark on the water level indicator (3) and close the lid (10) by pressing it down
until it clicks into place.
When the kettle (4) is placed on the base (5), it can be freely rotated 360°
around the vertical axis. It does not need to engage in a certain position. This
allows you to rotate the kettle (4) such that you can easily check the water level
indicator (3) and rotate the kettle (4) so that the steam is directed away from
you.

Plug the mains plug into an easily accessible wall outlet.

Place the kettle (4) onto the base (5) and press the ON/OFF switch (6) down to switch the
kettle (4) on. The power indicator integrated into the ON/OFF switch (6) lights up blue. The
kettle (4) will make noises during the heating process. This is not a malfunction.
12 - English