Accessories - OHAUS Scout Bedienungsanleitung

EN-6
Command Function
C Begin Span Calibration
AC Abort Calibration.
PSN Print Serial Number.
PV Print Version: print name, software revision and LFT ON (if LFT is set ON).
x# Set Counting APW (x) in grams. (must have APW stored)
P# Print Counting application APW.
x% Set Percent application reference weight (x) in grams. (must have reference
weight stored)
P% Print Percent application reference weight.
xCO Set Checkweighing Over Limit in grams x.
xCU Set Checkweighing Under Limit in grams x.
PCO Print Checkweighing Over Limit.
PCU Print Checkweighing Under Limit.
xMM Set Molar Mass in g/mol .
PMM Print Molar Mass
xS 0 = print unstable data, 1 = print stable only
0 = New Print format (default) ; 1 = Scout Pro Print format
xFMT
xRL 0 = disable response; 1 = enable response.

ACCESSORIES

For a complete listing of OHAUS printers and other accessories, contact OHAUS
Corporation or visit www.ohaus.com.
COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
USB Device Interface