Remote Controller - Hitachi RAK-60PPA Bedienungsanleitung

NAMES AND FUNCTIONS OF REMOTE CONTROLLER

REMOTE CONTROLLER

This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting is
●
controlled electronically, the range of controller may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
Handle the remote controller with care. Dropping it or getting it wet may compromise its signal transmission
●
capability.
After new batteries are inserted into the remote controller, the unit will initially require approximately 10
●
seconds to respond to commands and operate.
When remote controller is not in use for about 3 minutes during OFF condition, indicated by
●
display, the LCD will turn off.
During clock setting, the LCD will turn off about 10 minutes later if the remote controller is not in use.
●
When pressing any button, the LCD will turn on.
●
The LCD will not turn off during TIMER setting.
●
Signal Transmitting/Receiving
Window
Point this window towards the
indoor unit when controlling it.
Sensor
A temperature sensor inside the
remote controller senses ambient
temperature around the remote-
controller.
Display
This indicates the room temperature
selected, current time, timer status,
function and airflow rate selected.
ROOM TEMPERATURE setting Buttons
Press these buttons to set the room
temperature.
Press the [ ] button to raise the room
temperature.
Press the [ ] button to lower the room
temperature.
Keep pressing and the value will change
more quickly.
Transmission sign
The transmission sign lights up
when a signal is sent.
START/STOP button
Press this button to start
operation. Press it again to stop
operation.
FAN SPEED selector Button
This determines the fan speed.
Every time you press this button
the
(SILENT) (This button allows
selection of
fan speed for each operation mode).
ECO Button
Use this button to set the ECO
mode.(
– 8 –
– 8 –
on the
airflow rate will ch ange from
(AUTO) ➔ (HIG H)
(MED) ➔ (LOW)
➔
optimal or preferred
p.18)
➔