Operating Conditions; Technical Data - Intenso ENERGY ECO CHARGER Version 1.0 Bedienungsanleitung

Never charge damaged, corroded or leaking batteries.
Never attempt to charge batteries that are not intended for recharging with this device. There is
a risk of fire or explosion!
Protect the device from impact and falling in any operating mode.
Do not disassemble the device and do not attempt to repair it yourself. It does not contain any
parts that require service and the warranty will be invalid in this event.
Do not insert any objects into the product's loading bays. This could lead to a short circuit and a
resulting fire.
Do not operate this device with wet hands.
Do not use water or chemical solutions to clean the product. Please use a dry cloth only. To
ensure proper operation, clean the charging bay contacts regularly.
The device develops slight heat during use, this is normal. Do not cover the product during use.
If the device gets unusually hot, disconnect it from the power socket immediately. Ensure your
safety and prevent skin burnings by using gloves, dry towels or suchlike.
Do not use the device if it shows visible damage or has become damp.
When not in use or when the batteries are fully charged, unplug the device.
Do not use the unit if you intend to leave the room for an extended period of time.
If a battery loses liquid, protect yourself from direct skin contact and dispose of the battery
properly.

OPERATING CONDITIONS

Operate the device at 0 to 40 degrees Celsius, ideally at a room temperature of 25 degrees
Celsius. If you will not be using the device for a long time, store it between -20 and 65 degrees
Celsius, ideally at a temperature of 25 degrees Celsius.

TECHNICAL DATA

Dimensions:
Usable batteries:
Input voltage:
Charging voltage:
Charge current:
Trickle charging current:
Automatic charging timeout:
Status display:
113 x 68 x 76 mm
NiMH or NiCd
AAA (HR03/KR03) or AA (HR6/KR6)
100-240VAC, 50/60Hz
2 independent channels with 2.8 Volt DC
can each charge 2 batteries. Batteries can
only be charged in pairs.
AA: 250 mA I AAA: 120 mA
AA/AAA: 10mA
10 hours
4 LED lights
EN - Page 6 of 8