Camp Safety TRIPOD EVO Gebrauchsanweisung Seite 12

SECTION 4 - RESCUE ACCORDING TO EN 1496/B
GENERAL PRECAUTIONS FOR RESCUE:
Ÿ Secondary fall arrest system (conforming EN 363) must be used when working with the TRIPOD EVO and ref.0284-028401.
Ÿ Fall arrest and rescue systems used with this device MUST MEET applicable EN standards requirements (EN 795 for
anchor devices; EN 362 for connectors; EN 361 for full body harnesses; EN 360 for retractable type fall arresters; EN 1496
for rescue lifting devices; EN 1497 for rescue harnesses; EN 341 for descender devices).
Ÿ For rescue purposes with ref.0284-028401 rescue lifting device always use energy absorber (component of ref.0284-
028401 set).
Ÿ During installing rescue lifting ref.0284-028401 locking pin MUST BE embedded in locking hole. Only then rescue lifting
device can be safely and firmly installed on the tripod leg.
USAGE TRIPOD EVO SAFETY TRIPOD FOR RESCUE PURPOSES
TRIPOD EVO safety tripod can be used for rescue purposes in conjuction with ref.0284-028401 rescue lifting devices.
RESCUE EN 1496/B
ref.0284 - 20 m
ref.028401 - 25 m
TRIPOD EVO + equipment
Max. number of users at the same time
Working Load Limit
INSTALLING ref.0284-028401 RESCUE LIFTING DEVICE
The tripod can be used with ref.0284-028401 rescue lifting
device. ref.0284-028401 should be installed on the tripod legs.
The grip of the ref.0284-028401 should be fastened on the
locking hole situated on the inner wall of the outside part of leg.
The cable should be guided through rope pulley attached to the
central attachment point or one of side attachment points. For
proper and safe installation and use of the ref.0284-028401
follow its manual.
Fit the locking pin into the
leg hole in the tripod leg
ref.0284-028401
1
140 kg
ref.0284-028401
cable
Energy absorber
ref.0284-028401
Rupe pulley attached to the
entral attachment point
Leg attachment
point (locking hole)
EN 6/6